| Rfc | 5187 |
|---|
| Title | OSPFv3 Graceful Restart |
|---|
| Author | P. Pillay-Esnault, A. Lindem |
|---|
| Date | June 2008 |
|---|
| Format: | TXT, HTML |
|---|
| Status: | PROPOSED STANDARD |
|---|
|
Network Working Group P. Pillay-Esnault
Request for Comments: 5187 Cisco Systems
Category: Standards Track A. Lindem
Redback Networks
June 2008
OSPFv3 Graceful Restart
Status of This Memo
This document specifies an Internet standards track protocol for the
Internet community, and requests discussion and suggestions for
improvements. Please refer to the current edition of the "Internet
Official Protocol Standards" (STD 1) for the standardization state
and status of this protocol. Distribution of this memo is unlimited.
Abstract
This document describes the OSPFv3 graceful restart. The OSPFv3
graceful restart is identical to that of OSPFv2 except for the
differences described in this document. These differences include
the format of the grace Link State Advertisements (LSAs) and other
considerations.
Table of Contents
1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . 2
2. Grace Link State Advertisement . . . . . . . . . . . . . . . . 2
2.1. Grace LSA - LS Type . . . . . . . . . . . . . . . . . . . . 2
2.2. Grace LSA Format . . . . . . . . . . . . . . . . . . . . . 3
3. Additional Considerations for OSPFv3 Graceful Restart . . . . . 4
3.1. Preservation of LSA ID to Prefix Correspondence . . . . . . 4
3.2. Preservation of Interface IDs for Link-LSAs,
Network-LSAs, and Router-LSAs . . . . . . . . . . . . . . . 4
4. Security Considerations . . . . . . . . . . . . . . . . . . . . 5
5. IANA Considerations . . . . . . . . . . . . . . . . . . . . . . 5
6. Acknowledgments . . . . . . . . . . . . . . . . . . . . . . . . 5
7. References . . . . . . . . . . . . . . . . . . . . . . . . . . 5
7.1. Normative References . . . . . . . . . . . . . . . . . . . 5
7.2. Informative References . . . . . . . . . . . . . . . . . . 6
1. Introduction
Graceful OSPF restart [GRACE] describes a mechanism to restart the
control plane of an OSPFv2 [OSPFv2] router that still has its
forwarding plane intact with a minimum of disruption to the network.
In general, the methods described in [GRACE] work for OSPFv3 [OSPFv3]
as well. However, OSPFv3 will use a grace-LSA with a different
format to signal that a router is initiating (or is about to
initiate) a graceful restart. This document describes other OSPFv3
differences as well.
The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
"SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
document are to be interpreted as described in [RFC2119].
2. Grace Link State Advertisement
An OSPFv3 router initiating a graceful restart of its OSPFv3 software
originates grace-LSAs. A grace-LSA requests that the router's
neighbors aid in its graceful restart by continuing to advertise the
router as fully adjacent during the specified grace period. The
grace-LSA contains the restarting router grace-period and the reason
code indicating the reason for the graceful restart.
In OSPFv3 (refer to section 2.11 of [OSPFv3]), neighboring routers on
any link are always identified by their router IDs. This contrasts
with the OSPFv2 behavior where neighbors on point-to-point networks
and virtual links are identified by their Router IDs, while neighbors
on broadcast, Non-Broadcast Multi-Access (NBMA), and point-to-
multipoint links are identified by their IPv4 interface addresses.
Consequently, there is no requirement for the router-address TLV
[GRACE] for OSPFv3 graceful restart.
The TLV formats of the grace-LSA described in [GRACE] remain
unchanged.
2.1. Grace LSA - LS Type
A grace-LSA is defined as an LSA with the LS type equal to 0x000b.
LSA function code LS Type Description
------------------------------------------
11 0x000b GRACE-LSA
Grace-LSA Type and Function Code
The S2-bit and S1-bit are set to 0 to indicate link-local flooding
scope. The U-bit is set to 0 since it isn't applicable to LSAs with
link-local flooding scope.
2.2. Grace LSA Format
The format of a grace LSA is:
0 1 2 3
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| LS age |0|0|0| 11 |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Link State ID |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Advertising Router |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| LS sequence number |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| LS checksum | Length |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| |
+- TLVs -+
| ... |
Grace-LSA Format
The Link State ID of a grace-LSA in OSPFv3 is the Interface ID of the
interface originating the LSA.
The format of each TLV is:
0 1 2 3
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Type | Length |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Value... |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
TLV Format
Grace-LSA TLVs are formatted according to section 2.3.2 of [OSPF-TE].
The following is the list of TLVs that can appear in the body of a
grace-LSA.
Grace Period (Type=1, Length=4). The number of seconds that the
router's neighbors should continue to advertise the router as
fully adjacent, regardless of the state of database
synchronization between the router and its neighbors. This TLV
MUST always appear in a grace-LSA.
Graceful restart reason (Type=2, Length=1). Encodes the reason
for the router restart, as one of the following: 0 (unknown), 1
(software restart), 2 (software reload/upgrade), or 3 (switch to
redundant control processor). This TLV MUST always appear in a
grace-LSA.
3. Additional Considerations for OSPFv3 Graceful Restart
This section describes OSPFv3 unique considerations in addition to
those described in [GRACE].
3.1. Preservation of LSA ID to Prefix Correspondence
In OSPFv2, there is a direct correspondence between summary and
external LSA IDs and the prefixes being advertised. However, in
OSPFv3, the LSA ID for inter-area prefix LSAs and external LSAs is
simply an unsigned 32-bit integer. Hence, to avoid network churn
during graceful restart, the restarting router MUST preserve the LSA
ID to prefix correspondence across graceful restarts.
3.2. Preservation of Interface IDs for Link-LSAs, Network-LSAs, and
Router-LSAs
In OSPFv3, the LSA ID for Link-LSAs and Network-LSAs and link
descriptions in Router-LSAs map to their corresponding Interface ID.
Changes in the Interface ID during graceful restart will result in a
mismatch between the restarting router's pre-restart LSAs and its
neighbor adjacency state. These disparities will cause the graceful
restart to terminate prematurely.
Synchronizing Interface ID changes between neighbors is possible.
However, placing the burden on the restarting router to preserve
Interface IDs across restarts provides for a more robust, more
deterministic, and simpler mechanism. Therefore, the OSPFv3
Interface ID, as described in section 3.1.2 of [OSPFv3], MUST be
preserved by the restarting router across restarts.
Many implementations currently use the interface's MIB-II IfIndex
[MIB-INTF] for Interface ID. The persistence of Interface ID across
reboots is described in section 3.1.5 of [MIB-PERS].
4. Security Considerations
[OSPFv3-AUTH] relies on manual key distribution which precludes the
use of replay protection that utilizes sequence numbers. The replay
of an OSPF Link-Update containing a grace-LSA would allow an attacker
to deceive neighboring routers into believing that a router that has
been taken out of service (either intentionally or via a malicious
action by the same attacker) is still active and is in the process of
graceful restart. However, this attack is much more difficult than
the obvious replay of standard OSPFv3 hello packets to accomplish the
same thing by keeping the adjacency up. Since hello packets are sent
more predictably and knowledge of the key is not required, the risk
added by OSPFv3 graceful restart is insignificant. Hence, this
document does not raise any new security concerns other than those
covered in [OSPFv3], [OSPFv3-AUTH], and [GRACE].
5. IANA Considerations
A new LSA function code has been assigned for the OSPFv3 grace-LSA.
The assignment of 0x000b has been made in the "OSPFv3 LSA Function
Codes" sub-registry of the "Open Shortest Path First v3 (OSPFv3)
Parameters" registry. OSPFv3 grace-LSA TLVs and sub-TLVs use the
"OSPFv2 Grace LSA Top Level TLV" IANA sub-registry of the "Open
Shortest Path First v2 (OSPFv2) Parameters" registry.
6. Acknowledgments
Many thanks to Kireeti Kompella, Les Ginsberg, and David Ward with
whom much of this was discussed. The authors also wish to thank
Kunihiro Ishiguro and Vivek Dubey for their comments.
This document was produced using Marshall Rose's xml2rfc tool.
7. References
7.1. Normative References
[GRACE] Moy, J., Pillay-Esnault, P., and A. Lindem, "Graceful
OSPF Restart", RFC 3623, November 2003.
[OSPF-TE] Katz, D., Yeung, D., and K. Kompella, "Traffic
Engineering Extensions to OSPF", RFC 3630,
September 2003.
[OSPFv2] Moy, J., "OSPF Version 2", STD 54, RFC 2328,
April 1998.
[OSPFv3] Moy, J., Ferguson, D., and R. Coltun, "OSPF for IPv6",
RFC 2740, March 1997.
[RFC2119] Bradner, S., "Key words for use in RFC's to Indicate
Requirement Levels", BCP 14, RFC 2119, March 1997.
7.2. Informative References
[MIB-INTF] McCloghrie, K. and M. Rose, "Management Information
Base for network management of TCP/IP-based internets:
MIB-II", STD 17, RFC 1213, March 1991.
[MIB-PERS] McCloghrie, K. and F. Kastenholz, "The Interfaces
Group MIB", RFC 2863, June 2000.
[OSPFv3-AUTH] Gupta, M. and N. Melam, "Authentication/
Confidentiality for OSPFv3", RFC 4552, June 2006.
Authors' Addresses
Padma Pillay-Esnault
Cisco Systems
3750 Cisco Way
San Jose, CA 95134
USA
EMail: ppe@cisco.com
Acee Lindem
Redback Networks
102 Carric Bend Court
Cary, NC 27519
USA
EMail: acee@redback.com
Full Copyright Statement
Copyright (C) The IETF Trust (2008).
This document is subject to the rights, licenses and restrictions
contained in BCP 78, and except as set forth therein, the authors
retain all their rights.
This document and the information contained herein are provided on an
"AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS
OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY, THE IETF TRUST AND
THE INTERNET ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS
OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF
THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED
WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
Intellectual Property
The IETF takes no position regarding the validity or scope of any
Intellectual Property Rights or other rights that might be claimed to
pertain to the implementation or use of the technology described in
this document or the extent to which any license under such rights
might or might not be available; nor does it represent that it has
made any independent effort to identify any such rights. Information
on the procedures with respect to rights in RFC documents can be
found in BCP 78 and BCP 79.
Copies of IPR disclosures made to the IETF Secretariat and any
assurances of licenses to be made available, or the result of an
attempt made to obtain a general license or permission for the use of
such proprietary rights by implementers or users of this
specification can be obtained from the IETF on-line IPR repository at
http://www.ietf.org/ipr.
The IETF invites any interested party to bring to its attention any
copyrights, patents or patent applications, or other proprietary
rights that may cover technology that may be required to implement
this standard. Please address the information to the IETF at
ietf-ipr@ietf.org.