Rfc2818
TitleHTTP Over TLS
AuthorE. Rescorla
DateMay 2000
Format:TXT, HTML
Updated byRFC5785, RFC7230
Status:INFORMATIONAL






Network Working Group                                       E. Rescorla
Request for Comments: 2818                                   RTFM, Inc.
Category: Informational                                        May 2000


                             HTTP Over TLS

Status of this Memo

   This memo provides information for the Internet community.  It does
   not specify an Internet standard of any kind.  Distribution of this
   memo is unlimited.

Copyright Notice

   Copyright (C) The Internet Society (2000).  All Rights Reserved.

Abstract

   This memo describes how to use TLS to secure HTTP connections over
   the Internet. Current practice is to layer HTTP over SSL (the
   predecessor to TLS), distinguishing secured traffic from insecure
   traffic by the use of a different server port. This document
   documents that practice using TLS. A companion document describes a
   method for using HTTP/TLS over the same port as normal HTTP
   [RFC2817].

Table of Contents

   1. Introduction  . . . . . . . . . . . . . . . . . . . . . . 2
   1.1. Requirements Terminology  . . . . . . . . . . . . . . . 2
   2. HTTP Over TLS . . . . . . . . . . . . . . . . . . . . . . 2
   2.1. Connection Initiation . . . . . . . . . . . . . . . . . 2
   2.2. Connection Closure  . . . . . . . . . . . . . . . . . . 2
   2.2.1. Client Behavior . . . . . . . . . . . . . . . . . . . 3
   2.2.2. Server Behavior . . . . . . . . . . . . . . . . . . . 3
   2.3. Port Number . . . . . . . . . . . . . . . . . . . . . . 4
   2.4. URI Format  . . . . . . . . . . . . . . . . . . . . . . 4
   3. Endpoint Identification . . . . . . . . . . . . . . . . . 4
   3.1. Server Identity . . . . . . . . . . . . . . . . . . . . 4
   3.2. Client Identity . . . . . . . . . . . . . . . . . . . . 5
   References . . . . . . . . . . . . . . . . . . . . . . . . . 6
   Security Considerations  . . . . . . . . . . . . . . . . . . 6
   Author's Address . . . . . . . . . . . . . . . . . . . . . . 6
   Full Copyright Statement . . . . . . . . . . . . . . . . . . 7






RFC 2818                     HTTP Over TLS                      May 2000


1.  Introduction

   HTTP [RFC2616] was originally used in the clear on the Internet.
   However, increased use of HTTP for sensitive applications has
   required security measures. SSL, and its successor TLS [RFC2246] were
   designed to provide channel-oriented security. This document
   describes how to use HTTP over TLS.

1.1.  Requirements Terminology

   Keywords "MUST", "MUST NOT", "REQUIRED", "SHOULD", "SHOULD NOT" and
   "MAY" that appear in this document are to be interpreted as described
   in [RFC2119].

2.  HTTP Over TLS

   Conceptually, HTTP/TLS is very simple. Simply use HTTP over TLS
   precisely as you would use HTTP over TCP.

2.1.  Connection Initiation

   The agent acting as the HTTP client should also act as the TLS
   client.  It should initiate a connection to the server on the
   appropriate port and then send the TLS ClientHello to begin the TLS
   handshake. When the TLS handshake has finished. The client may then
   initiate the first HTTP request.  All HTTP data MUST be sent as TLS
   "application data".  Normal HTTP behavior, including retained
   connections should be followed.

2.2.  Connection Closure

   TLS provides a facility for secure connection closure. When a valid
   closure alert is received, an implementation can be assured that no
   further data will be received on that connection.  TLS
   implementations MUST initiate an exchange of closure alerts before
   closing a connection. A TLS implementation MAY, after sending a
   closure alert, close the connection without waiting for the peer to
   send its closure alert, generating an "incomplete close".  Note that
   an implementation which does this MAY choose to reuse the session.
   This SHOULD only be done when the application knows (typically
   through detecting HTTP message boundaries) that it has received all
   the message data that it cares about.

   As specified in [RFC2246], any implementation which receives a
   connection close without first receiving a valid closure alert (a
   "premature close") MUST NOT reuse that session.  Note that a
   premature close does not call into question the security of the data
   already received, but simply indicates that subsequent data might



RFC 2818                     HTTP Over TLS                      May 2000


   have been truncated. Because TLS is oblivious to HTTP
   request/response boundaries, it is necessary to examine the HTTP data
   itself (specifically the Content-Length header) to determine whether
   the truncation occurred inside a message or between messages.

2.2.1.  Client Behavior

   Because HTTP uses connection closure to signal end of server data,
   client implementations MUST treat any premature closes as errors and
   the data received as potentially truncated.  While in some cases the
   HTTP protocol allows the client to find out whether truncation took
   place so that, if it received the complete reply, it may tolerate
   such errors following the principle to "[be] strict when sending and
   tolerant when receiving" [RFC1958], often truncation does not show in
   the HTTP protocol data; two cases in particular deserve special note:

     A HTTP response without a Content-Length header. Since data length
     in this situation is signalled by connection close a premature
     close generated by the server cannot be distinguished from a
     spurious close generated by an attacker.

     A HTTP response with a valid Content-Length header closed before
     all data has been read. Because TLS does not provide document
     oriented protection, it is impossible to determine whether the
     server has miscomputed the Content-Length or an attacker has
     truncated the connection.

   There is one exception to the above rule. When encountering a
   premature close, a client SHOULD treat as completed all requests for
   which it has received as much data as specified in the Content-Length
   header.

   A client detecting an incomplete close SHOULD recover gracefully.  It
   MAY resume a TLS session closed in this fashion.

   Clients MUST send a closure alert before closing the connection.
   Clients which are unprepared to receive any more data MAY choose not
   to wait for the server's closure alert and simply close the
   connection, thus generating an incomplete close on the server side.

2.2.2.  Server Behavior

   RFC 2616 permits an HTTP client to close the connection at any time,
   and requires servers to recover gracefully.  In particular, servers
   SHOULD be prepared to receive an incomplete close from the client,
   since the client can often determine when the end of server data is.
   Servers SHOULD be willing to resume TLS sessions closed in this
   fashion.



RFC 2818                     HTTP Over TLS                      May 2000


   Implementation note: In HTTP implementations which do not use
   persistent connections, the server ordinarily expects to be able to
   signal end of data by closing the connection. When Content-Length is
   used, however, the client may have already sent the closure alert and
   dropped the connection.

   Servers MUST attempt to initiate an exchange of closure alerts with
   the client before closing the connection. Servers MAY close the
   connection after sending the closure alert, thus generating an
   incomplete close on the client side.

2.3.  Port Number

   The first data that an HTTP server expects to receive from the client
   is the Request-Line production. The first data that a TLS server (and
   hence an HTTP/TLS server) expects to receive is the ClientHello.
   Consequently, common practice has been to run HTTP/TLS over a
   separate port in order to distinguish which protocol is being used.
   When HTTP/TLS is being run over a TCP/IP connection, the default port
   is 443. This does not preclude HTTP/TLS from being run over another
   transport. TLS only presumes a reliable connection-oriented data
   stream.

2.4.  URI Format

   HTTP/TLS is differentiated from HTTP URIs by using the 'https'
   protocol identifier in place of the 'http' protocol identifier. An
   example URI specifying HTTP/TLS is:

     https://www.example.com/~smith/home.html

3.  Endpoint Identification

3.1.  Server Identity

   In general, HTTP/TLS requests are generated by dereferencing a URI.
   As a consequence, the hostname for the server is known to the client.
   If the hostname is available, the client MUST check it against the
   server's identity as presented in the server's Certificate message,
   in order to prevent man-in-the-middle attacks.

   If the client has external information as to the expected identity of
   the server, the hostname check MAY be omitted. (For instance, a
   client may be connecting to a machine whose address and hostname are
   dynamic but the client knows the certificate that the server will
   present.) In such cases, it is important to narrow the scope of
   acceptable certificates as much as possible in order to prevent man




RFC 2818                     HTTP Over TLS                      May 2000


   in the middle attacks.  In special cases, it may be appropriate for
   the client to simply ignore the server's identity, but it must be
   understood that this leaves the connection open to active attack.

   If a subjectAltName extension of type dNSName is present, that MUST
   be used as the identity. Otherwise, the (most specific) Common Name
   field in the Subject field of the certificate MUST be used. Although
   the use of the Common Name is existing practice, it is deprecated and
   Certification Authorities are encouraged to use the dNSName instead.

   Matching is performed using the matching rules specified by
   [RFC2459].  If more than one identity of a given type is present in
   the certificate (e.g., more than one dNSName name, a match in any one
   of the set is considered acceptable.) Names may contain the wildcard
   character * which is considered to match any single domain name
   component or component fragment. E.g., *.a.com matches foo.a.com but
   not bar.foo.a.com. f*.com matches foo.com but not bar.com.

   In some cases, the URI is specified as an IP address rather than a
   hostname. In this case, the iPAddress subjectAltName must be present
   in the certificate and must exactly match the IP in the URI.

   If the hostname does not match the identity in the certificate, user
   oriented clients MUST either notify the user (clients MAY give the
   user the opportunity to continue with the connection in any case) or
   terminate the connection with a bad certificate error. Automated
   clients MUST log the error to an appropriate audit log (if available)
   and SHOULD terminate the connection (with a bad certificate error).
   Automated clients MAY provide a configuration setting that disables
   this check, but MUST provide a setting which enables it.

   Note that in many cases the URI itself comes from an untrusted
   source. The above-described check provides no protection against
   attacks where this source is compromised. For example, if the URI was
   obtained by clicking on an HTML page which was itself obtained
   without using HTTP/TLS, a man in the middle could have replaced the
   URI.  In order to prevent this form of attack, users should carefully
   examine the certificate presented by the server to determine if it
   meets their expectations.

3.2.  Client Identity

   Typically, the server has no external knowledge of what the client's
   identity ought to be and so checks (other than that the client has a
   certificate chain rooted in an appropriate CA) are not possible. If a
   server has such knowledge (typically from some source external to
   HTTP or TLS) it SHOULD check the identity as described above.




RFC 2818                     HTTP Over TLS                      May 2000


References

   [RFC2459] Housley, R., Ford, W., Polk, W. and D. Solo, "Internet
             Public Key Infrastructure: Part I: X.509 Certificate and
             CRL Profile", RFC 2459, January 1999.

   [RFC2616] Fielding, R., Gettys, J., Mogul, J., Frystyk, H., Masinter,
             L., Leach, P. and T. Berners-Lee, "Hypertext Transfer
             Protocol, HTTP/1.1", RFC 2616, June 1999.

   [RFC2119] Bradner, S., "Key Words for use in RFCs to indicate
             Requirement Levels", BCP 14, RFC 2119, March 1997.

   [RFC2246] Dierks, T. and C. Allen, "The TLS Protocol", RFC 2246,
             January 1999.

   [RFC2817] Khare, R. and S. Lawrence, "Upgrading to TLS Within
             HTTP/1.1", RFC 2817, May 2000.

Security Considerations

   This entire document is about security.

Author's Address

   Eric Rescorla
   RTFM, Inc.
   30 Newell Road, #16
   East Palo Alto, CA 94303

   Phone: (650) 328-8631
   EMail: ekr@rtfm.com



















RFC 2818                     HTTP Over TLS                      May 2000


Full Copyright Statement

   Copyright (C) The Internet Society (2000).  All Rights Reserved.

   This document and translations of it may be copied and furnished to
   others, and derivative works that comment on or otherwise explain it
   or assist in its implementation may be prepared, copied, published
   and distributed, in whole or in part, without restriction of any
   kind, provided that the above copyright notice and this paragraph are
   included on all such copies and derivative works.  However, this
   document itself may not be modified in any way, such as by removing
   the copyright notice or references to the Internet Society or other
   Internet organizations, except as needed for the purpose of
   developing Internet standards in which case the procedures for
   copyrights defined in the Internet Standards process must be
   followed, or as required to translate it into languages other than
   English.

   The limited permissions granted above are perpetual and will not be
   revoked by the Internet Society or its successors or assigns.

   This document and the information contained herein is provided on an
   "AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING
   TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING
   BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION
   HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF
   MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

Acknowledgement

   Funding for the RFC Editor function is currently provided by the
   Internet Society.