| Rfc | 6769 |
|---|
| Title | Simple Virtual Aggregation (S-VA) |
|---|
| Author | R. Raszuk, J. Heitz, A. Lo, L.
Zhang, X. Xu |
|---|
| Date | October 2012 |
|---|
| Format: | TXT, HTML |
|---|
| Status: | INFORMATIONAL |
|---|
|
Internet Engineering Task Force (IETF) R. Raszuk
Request for Comments: 6769 NTT MCL
Category: Informational J. Heitz
ISSN: 2070-1721 Ericsson
A. Lo
Arista
L. Zhang
UCLA
X. Xu
Huawei
October 2012
Simple Virtual Aggregation (S-VA)
Abstract
All BGP routers in the Default-Free Zone (DFZ) are required to carry
all routes in the Default-Free Routing Table (DFRT). This document
describes a technique, Simple Virtual Aggregation (S-VA), that allows
some BGP routers not to install all of those routes into the
Forwarding Information Base (FIB).
Some routers in an Autonomous System (AS) announce an aggregate (the
VA prefix) in addition to the routes they already announce. This
enables other routers not to install the routes covered by the VA
prefix into the FIB as long as those routes have the same next-hop as
the VA prefix.
The VA prefixes that are announced within an AS are not announced to
any other AS. The described functionality is of very low operational
complexity, as it proposes a confined BGP speaker solution without
any dependency on network-wide configuration or requirement for any
form of intra-domain tunneling.
Status of This Memo
This document is not an Internet Standards Track specification; it is
published for informational purposes.
This document is a product of the Internet Engineering Task Force
(IETF). It represents the consensus of the IETF community. It has
received public review and has been approved for publication by the
Internet Engineering Steering Group (IESG). Not all documents
approved by the IESG are a candidate for any level of Internet
Standard; see Section 2 of RFC 5741.
Information about the current status of this document, any errata,
and how to provide feedback on it may be obtained at
http://www.rfc-editor.org/info/rfc6769.
Copyright Notice
Copyright (c) 2012 IETF Trust and the persons identified as the
document authors. All rights reserved.
This document is subject to BCP 78 and the IETF Trust's Legal
Provisions Relating to IETF Documents
(http://trustee.ietf.org/license-info) in effect on the date of
publication of this document. Please review these documents
carefully, as they describe your rights and restrictions with respect
to this document. Code Components extracted from this document must
include Simplified BSD License text as described in Section 4.e of
the Trust Legal Provisions and are provided without warranty as
described in the Simplified BSD License.
Table of Contents
1. Introduction ....................................................3
1.1. Scope of This Document .....................................3
1.2. Requirements Notation ......................................3
1.3. Terminology ................................................3
2. Operation of S-VA ...............................................4
3. Deployment Considerations .......................................6
4. Security Considerations .........................................7
5. Acknowledgements ................................................7
6. Normative References ............................................7
7. Informative References ..........................................7
1. Introduction
This document describes a technique called Simple Virtual Aggregation
(S-VA). It allows some routers not to store some routes in the
Forwarding Information Base (FIB) while still advertising and
receiving the full Default-Free Routing Table (DFRT) in BGP.
A typical scenario is as follows. Core routers in the ISP maintain
the full DFRT in the FIB and Routing Information Base (RIB). Edge
routers maintain the full DFRT in the BGP Local RIB (Loc-RIB), but do
not install certain routes in the RIB and FIB. Edge routers may
install a default route to core routers, to Area Border Routers (ABR)
that are installed on the Point of Presence (POP), to core boundary
routers, or to Autonomous System Border Routers (ASBRs).
S-VA must be enabled on an edge router that needs to save its RIB and
FIB space. The core routers must announce a new prefix called
Virtual Aggregate (VA prefix).
1.1. Scope of This Document
The VA prefix is not intended to be announced from one AS into
another, only between routers of the same AS.
S-VA can be used for both IPv4 unicast and multicast address families
and IPv6 unicast and multicast address families.
S-VA does not need to operate on every router in an AS.
1.2. Requirements Notation
The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
"SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
document are to be interpreted as described in [RFC2119].
1.3. Terminology
RIB/FIB-Installing Router (FIR): A router that does not suppress any
routes and announces the VA prefix. Typically, a core router, a
POP to core boundary router, or an ASBR would be configured as an
FIR.
RIB/FIB-Suppressing Router (FSR): An S-VA router that installs the
VA prefix, but does not install routes that are covered by and
have the same next-hop as the VA prefix into its FIB. Typically,
an edge router would be configured as an FSR.
Suppress: Not to install a route that is covered by the VA prefix
into the global RIB or FIB.
Legacy Router: A router that does not run S-VA and has no knowledge
of S-VA.
Global Routing Information Base (RIB): All routing protocols in a
router install their selected routes into the RIB. The routes in
the RIB are used to resolve next-hops for other routes, to be
redistributed to other routing protocols, and to be installed into
the FIB.
Local/Protocol Routing Information Base (Loc-RIB): The Loc-RIB
contains the routes that have been selected by the local BGP
speaker's Decision Process as in [RFC4271].
NLRI: Network Layer Reachability Information [RFC4271]
2. Operation of S-VA
There are three types of routers in S-VA: FIB-Installing routers
(FIR), FIB-Suppressing routers (FSR), and, optionally, legacy
routers. While any router can be an FIR or an FSR, the simplest form
of deployment is for AS border routers to be configured as FIRs and
for customer facing edge routers to be configured as FSRs.
When a FIR announces a VA prefix, it sets the path attributes as
follows. The ORIGIN MUST be set to INCOMPLETE (value 2). The
NEXT_HOP MUST be set to the same value as that of the routes that are
intended to be covered by the VA prefix. The ATOMIC_AGGREGATE and
AGGREGATOR attributes SHOULD NOT be included. The FIR MUST attach a
NO_EXPORT community attribute [RFC1997]. The NLRI SHOULD be 0/0.
A FIR SHOULD NOT FIB-suppress any routes.
An FSR must detect the VA prefix or prefixes (including 0/0) and
install them in all of Loc-RIB, RIB, and FIB. The FSR MAY suppress
any more-specific routes that carry the same next-hop as the VA
prefix.
Generally, any more-specific route that carries the same next-hop as
the VA prefix is eligible for suppression. However, provided that
there is at least one less-specific prefix with a different next-hop
between the VA prefix and the suppressed prefixes, then those
suppressed prefixes must be reinstalled.
An example with three prefixes can be considered where the VA-prefix
(prefix 1) is the least specific and covers prefix 2 and prefix 3.
Prefix 2 is less specific than prefix 3 and covers the latter. If
all three have the same next-hop, then only the bigger one, i.e.,
VA-Prefix, is announced. However, if prefix 2 has a different
next-hop, then it will need to be announced separately. In this
case, it is important to also announce prefix 3 separately.
Similarly, when Internal BGP (IBGP) multipath is enabled, and when
multiple VA prefixes form a multipath, only those more-specific
prefixes of which the set of next-hops are identical to the set of
next-hops of the VA prefix multipath are subject to suppression.
The expected behavior is illustrated in Figure 1. This figure shows
an AS with a FIR, FIR1, and an FSR, FSR1. FSR1 is an ASBR and is
connected to two external ASBRs, EP1 and EP2.
+------------------------------------------+
| Autonomous System | +----+
| | |EP1 |
| /---+---| |
| To ----\ +----+ +----+ / | +----+
| Other \|FIR1|----------|FSR1|/ |
|Routers /| | | |\ |
| ----/ +----+ +----+ \ | +----+
| \---+---|EP2 |
| | | |
| | +----+
+------------------------------------------+
Figure 1
Suppose that FSR1 has been enabled to perform S-VA. Originally, it
receives all routes from FIR1 (doing next-hop-self) as well as from
EP1 and EP2. FIR1 now will advertise a VA prefix 0/0 with the next-
hop set to itself. This will cause FSR1 to suppress all routes with
the same next-hop as the VA prefix. However, FSR1 will not suppress
any routes received from EP1 and EP2, because their next-hops are
different from that of the VA prefix.
Several FIRs may announce different S-VA prefixes. For example, in a
POP, each edge router can announce into the POP an S-VA prefix that
covers the addresses of the customers it services.
Several FIRs may announce the same S-VA prefix. In this case, an FSR
must choose to install only one of them. For example, two redundant
ASBRs, both of which announce the complete DFRT, may each also
announce the default route as an S-VA prefix into the AS.
S-VA may be used to split traffic among redundant exit routers. For
example, suppose in Figure 1 that EP1 and EP2 are two redundant ASBRs
that announce the complete DFRT. Each may also announce two S-VA
prefixes into the AS: 0/1 and 128/1. EP1 might announce 0/1 with
higher preference and EP2 might announce 128/1 with higher
preference. FIR1 will now install into its FIB 0/1 pointing to EP1
and 128/1 pointing to EP2. If either EP1 or EP2 were to fail, then
FSR1 would switch the traffic to the other exit router with a single
FIB installation of one S-VA prefix.
3. Deployment Considerations
BGP routes may be used to resolve next-hops for static routes or
other BGP routes. Because the default route does not imply
reachability of any destination, a router can be configured to not
resolve next-hops using the default route. In this case, S-VA should
not suppress a route that may be used to resolve a next-hop for
another route from installation into the RIB. It may still suppress
it from installation into the FIB.
Selected BGP routes in the RIB may be redistributed to other
protocols. If they no longer exist in the RIB, they will not be
redistributed. This is especially important when the conditional
redistribution is taking place based on the length of the prefix,
community value, etc. In those cases where a redistribution policy
is in place, S-VA implementation should refrain from suppressing
installation into the RIB routes matching such policy. It may still
suppress them from installation into the FIB.
A router may originate a network route or an aggregate route into
BGP. Some addresses covered by such a route may not exist. If this
router were to receive a packet for an unreachable address within an
originated route, it must not send that packet to the VA prefix
route. There are several ways to achieve this. One way is to have
the FIR aggregate the routes instead of the FSR. Another way is to
install a black hole route for the nonexistent addresses on the
originating router. This issue is not specific to S-VA, but
applicable to the general use of default routes.
Like any aggregate, an S-VA prefix may include more address space
than the sum of the prefixes it covers. As such, the S-VA prefix may
provide a route for a packet for which no real destination exists.
An FSR will forward such a packet to the FIR.
If an S-VA prefix changes its next-hop or is removed, then many
routes may need to be downloaded into the FIB to achieve convergence.
4. Security Considerations
The authors are not aware of any new security considerations due to
S-VA. The local nature of the proposed optimization eliminates any
external exposure of the functionality. The presence of more
specifics that are used as VA prefixes is also a normal BGP behavior
in current networks.
5. Acknowledgements
The concept for Virtual Aggregation comes from Paul Francis. In this
document, the authors only simplified some aspects of its behavior to
allow simpler adoption by some operators.
The authors would like to thank Clarence Filsfils, Nick Hilliard, S.
Moonesamy, and Tom Petch for their review and valuable input.
6. Normative References
[RFC1997] Chandra, R., Traina, P., and T. Li, "BGP Communities
Attribute", RFC 1997, August 1996.
[RFC2119] Bradner, S., "Key words for use in RFCs to Indicate
Requirement Levels", BCP 14, RFC 2119, March 1997.
[RFC5082] Gill, V., Heasley, J., Meyer, D., Savola, P., Ed., and C.
Pignataro, "The Generalized TTL Security Mechanism
(GTSM)", RFC 5082, October 2007.
7. Informative References
[RFC4271] Rekhter, Y., Ed., Li, T., Ed., and S. Hares, Ed., "A
Border Gateway Protocol 4 (BGP-4)", RFC 4271, January
2006.
Authors' Addresses
Robert Raszuk
NTT MCL
101 S Ellsworth Avenue Suite 350
San Mateo, CA 94401
USA
EMail: robert@raszuk.net
Jakob Heitz
Ericsson
300 Holger Way
San Jose, CA 95134
USA
EMail: jakob.heitz@ericsson.com
Alton Lo
Arista Networks
5470 Great America Parkway
Santa Clara, CA 95054
USA
EMail: altonlo@aristanetworks.com
Lixia Zhang
UCLA
3713 Boelter Hall
Los Angeles, CA 90095
USA
EMail: lixia@cs.ucla.edu
Xiaohu Xu
Huawei Technologies
Huawei Building, No.3 Xinxi Rd.,
Shang-Di Information Industry Base, Hai-Dian District
Beijing 100085
P.R. China
Phone: +86 10 82836073
EMail: xuxh@huawei.com