| Rfc | 4955 |
|---|
| Title | DNS Security (DNSSEC) Experiments |
|---|
| Author | D. Blacka |
|---|
| Date | July 2007 |
|---|
| Format: | TXT, HTML |
|---|
| Status: | PROPOSED STANDARD |
|---|
|
Network Working Group D. Blacka
Request for Comments: 4955 VeriSign, Inc.
Category: Standards Track July 2007
DNS Security (DNSSEC) Experiments
Status of This Memo
This document specifies an Internet standards track protocol for the
Internet community, and requests discussion and suggestions for
improvements. Please refer to the current edition of the "Internet
Official Protocol Standards" (STD 1) for the standardization state
and status of this protocol. Distribution of this memo is unlimited.
Copyright Notice
Copyright (C) The IETF Trust (2007).
Abstract
This document describes a methodology for deploying alternate, non-
backwards-compatible, DNS Security (DNSSEC) methodologies in an
experimental fashion without disrupting the deployment of standard
DNSSEC.
Table of Contents
1. Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
2. Definitions and Terminology . . . . . . . . . . . . . . . . . . 2
3. Experiments . . . . . . . . . . . . . . . . . . . . . . . . . . 2
4. Method . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
5. Defining an Experiment . . . . . . . . . . . . . . . . . . . . 4
6. Considerations . . . . . . . . . . . . . . . . . . . . . . . . 5
7. Use in Non-Experiments . . . . . . . . . . . . . . . . . . . . 5
8. Security Considerations . . . . . . . . . . . . . . . . . . . . 5
9. References . . . . . . . . . . . . . . . . . . . . . . . . . . 6
9.1. Normative References . . . . . . . . . . . . . . . . . . . 6
9.2. Informative References . . . . . . . . . . . . . . . . . . 6
1. Overview
Historically, experimentation with DNSSEC alternatives has been a
problematic endeavor. There has typically been a desire to both
introduce non-backwards-compatible changes to DNSSEC and to try these
changes on real zones in the public DNS. This creates a problem when
the change to DNSSEC would make all or part of the zone using those
changes appear bogus (bad) or otherwise broken to existing security-
aware resolvers.
This document describes a standard methodology for setting up DNSSEC
experiments. This methodology addresses the issue of coexistence
with standard DNSSEC and DNS by using unknown algorithm identifiers
to hide the experimental DNSSEC protocol modifications from standard
security-aware resolvers.
2. Definitions and Terminology
Throughout this document, familiarity with the DNS system (RFC 1035
[5]) and the DNS security extensions (RFC 4033 [2], RFC 4034 [3], and
RFC 4035 [4]) is assumed.
The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
"SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
document are to be interpreted as described in RFC 2119 [1].
3. Experiments
When discussing DNSSEC experiments, it is necessary to classify these
experiments into two broad categories:
Backwards-Compatible: describes experimental changes that, while not
strictly adhering to the DNSSEC standard, are nonetheless
interoperable with clients and servers that do implement the
DNSSEC standard.
Non-Backwards-Compatible: describes experiments that would cause a
standard security-aware resolver to (incorrectly) determine that
all or part of a zone is bogus, or to otherwise not interoperate
with standard DNSSEC clients and servers.
Not included in these terms are experiments with the core DNS
protocol itself.
The methodology described in this document is not necessary for
backwards-compatible experiments, although it certainly may be used
if desired.
4. Method
The core of the methodology is the use of strictly unknown algorithm
identifiers when signing the experimental zone, and more importantly,
having only unknown algorithm identifiers in the DS records for the
delegation to the zone at the parent.
This technique works because of the way DNSSEC-compliant validators
are expected to work in the presence of a DS set with only unknown
algorithm identifiers. From RFC 4035 [4], Section 5.2:
If the validator does not support any of the algorithms listed in
an authenticated DS RRset, then the resolver has no supported
authentication path leading from the parent to the child. The
resolver should treat this case as it would the case of an
authenticated NSEC RRset proving that no DS RRset exists, as
described above.
And further:
If the resolver does not support any of the algorithms listed in
an authenticated DS RRset, then the resolver will not be able to
verify the authentication path to the child zone. In this case,
the resolver SHOULD treat the child zone as if it were unsigned.
Although this behavior isn't strictly mandatory (as marked by MUST),
it is unlikely for a validator to implement a substantially different
behavior. Essentially, if the validator does not have a usable chain
of trust to a child zone, then it can only do one of two things:
treat responses from the zone as insecure (the recommended behavior),
or treat the responses as bogus. If the validator chooses the
latter, this will both violate the expectation of the zone owner and
defeat the purpose of the above rule. However, with local policy, it
is within the right of a validator to refuse to trust certain zones
based on any criteria, including the use of unknown signing
algorithms.
Because we are talking about experiments, it is RECOMMENDED that
private algorithm numbers be used (see RFC 4034 [3], Appendix A.1.1.
Note that secure handling of private algorithms requires special
handing by the validator logic. See "Clarifications and
Implementation Notes for DNSSECbis" [6] for further details.)
Normally, instead of actually inventing new signing algorithms, the
recommended path is to create alternate algorithm identifiers that
are aliases for the existing, known algorithms. While, strictly
speaking, it is only necessary to create an alternate identifier for
the mandatory algorithms, it is suggested that all optional defined
algorithms be aliased as well.
It is RECOMMENDED that for a particular DNSSEC experiment, a
particular domain name base is chosen for all new algorithms, then
the algorithm number (or name) is prepended to it. For example, for
experiment A, the base name of "dnssec-experiment-a.example.com" is
chosen. Then, aliases for algorithms 3 (DSA) and 5 (RSASHA1) are
defined to be "3.dnssec-experiment-a.example.com" and
"5.dnssec-experiment-a.example.com". However, any unique identifier
will suffice.
Using this method, resolvers (or, more specifically, DNSSEC
validators) essentially indicate their ability to understand the
DNSSEC experiment's semantics by understanding what the new algorithm
identifiers signify.
This method creates two classes of security-aware servers and
resolvers: servers and resolvers that are aware of the experiment
(and thus recognize the experiment's algorithm identifiers and
experimental semantics), and servers and resolvers that are unaware
of the experiment.
This method also precludes any zone from being both in an experiment
and in a classic DNSSEC island of security. That is, a zone is
either in an experiment and only possible to validate experimentally,
or it is not.
5. Defining an Experiment
The DNSSEC experiment MUST define the particular set of (previously
unknown) algorithm identifiers that identify the experiment and
define what each unknown algorithm identifier means. Typically,
unless the experiment is actually experimenting with a new DNSSEC
algorithm, this will be a mapping of private algorithm identifiers to
existing, known algorithms.
Normally the experiment will choose a DNS name as the algorithm
identifier base. This DNS name SHOULD be under the control of the
authors of the experiment. Then the experiment will define a mapping
between known mandatory and optional algorithms into this private
algorithm identifier space. Alternately, the experiment MAY use the
Object Identifier (OID) private algorithm space instead (using
algorithm number 254), or MAY choose non-private algorithm numbers,
although this would require an IANA allocation.
For example, an experiment might specify in its description the DNS
name "dnssec-experiment-a.example.com" as the base name, and declare
that "3.dnssec-experiment-a.example.com" is an alias of DNSSEC
algorithm 3 (DSA), and that "5.dnssec-experiment-a.example.com" is an
alias of DNSSEC algorithm 5 (RSASHA1).
Resolvers MUST only recognize the experiment's semantics when present
in a zone signed by one or more of these algorithm identifiers. This
is necessary to isolate the semantics of one experiment from any
others that the resolver might understand.
In general, resolvers involved in the experiment are expected to
understand both standard DNSSEC and the defined experimental DNSSEC
protocol, although this isn't required.
6. Considerations
There are a number of considerations with using this methodology.
1. If an unaware validator does not correctly follow the rules laid
out in RFC 4035 (e.g., the validator interprets a DNSSEC record
prior to validating it), or if the experiment is broader in scope
that just modifying the DNSSEC semantics, the experiment may not
be sufficiently masked by this technique. This may cause
unintended resolution failures.
2. It will not be possible for security-aware resolvers unaware of
the experiment to build a chain of trust through an experimental
zone.
7. Use in Non-Experiments
This general methodology MAY be used for non-backwards compatible
DNSSEC protocol changes that start out as or become standards. In
this case:
o The protocol change SHOULD use public IANA allocated algorithm
identifiers instead of private algorithm identifiers. This will
help identify the protocol change as a standard, rather than an
experiment.
o Resolvers MAY recognize the protocol change in zones not signed
(or not solely signed) using the new algorithm identifiers.
8. Security Considerations
Zones using this methodology will be considered insecure by all
resolvers except those aware of the experiment. It is not generally
possible to create a secure delegation from an experimental zone that
will be followed by resolvers unaware of the experiment.
Implementers should take into account any security issues that may
result from environments being configured to trust both experimental
and non-experimental zones. If the experimental zone is more
vulnerable to attacks, it could, for example, be used to promote
trust in zones not part of the experiment, possibly under the control
of an attacker.
9. References
9.1. Normative References
[1] Bradner, S., "Key words for use in RFCs to Indicate Requirement
Levels", BCP 14, RFC 2119, March 1997.
[2] Arends, R., Austein, R., Larson, M., Massey, D., and S. Rose,
"DNS Security Introduction and Requirements", RFC 4033,
March 2005.
[3] Arends, R., Austein, R., Larson, M., Massey, D., and S. Rose,
"Resource Records for the DNS Security Extensions", RFC 4034,
March 2005.
[4] Arends, R., Austein, R., Larson, M., Massey, D., and S. Rose,
"Protocol Modifications for the DNS Security Extensions",
RFC 4035, March 2005.
9.2. Informative References
[5] Mockapetris, P., "Domain names - implementation and
specification", STD 13, RFC 1035, November 1987.
[6] Weiler, S. and R. Austein, "Clarifications and Implementation
Notes for DNSSECbis", Work in Progress, March 2007.
Author's Address
David Blacka
VeriSign, Inc.
21355 Ridgetop Circle
Dulles, VA 20166
US
Phone: +1 703 948 3200
EMail: davidb@verisign.com
URI: http://www.verisignlabs.com
Full Copyright Statement
Copyright (C) The IETF Trust (2007).
This document is subject to the rights, licenses and restrictions
contained in BCP 78, and except as set forth therein, the authors
retain all their rights.
This document and the information contained herein are provided on an
"AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS
OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY, THE IETF TRUST AND
THE INTERNET ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS
OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF
THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED
WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
Intellectual Property
The IETF takes no position regarding the validity or scope of any
Intellectual Property Rights or other rights that might be claimed to
pertain to the implementation or use of the technology described in
this document or the extent to which any license under such rights
might or might not be available; nor does it represent that it has
made any independent effort to identify any such rights. Information
on the procedures with respect to rights in RFC documents can be
found in BCP 78 and BCP 79.
Copies of IPR disclosures made to the IETF Secretariat and any
assurances of licenses to be made available, or the result of an
attempt made to obtain a general license or permission for the use of
such proprietary rights by implementers or users of this
specification can be obtained from the IETF on-line IPR repository at
http://www.ietf.org/ipr.
The IETF invites any interested party to bring to its attention any
copyrights, patents or patent applications, or other proprietary
rights that may cover technology that may be required to implement
this standard. Please address the information to the IETF at
ietf-ipr@ietf.org.
Acknowledgement
Funding for the RFC Editor function is currently provided by the
Internet Society.