Rfc | 6251 |
Title | Using Kerberos Version 5 over the Transport Layer Security (TLS)
Protocol |
Author | S. Josefsson |
Date | May 2011 |
Format: | TXT, HTML |
Status: | INFORMATIONAL |
|
Internet Engineering Task Force (IETF) S. Josefsson
Request for Comments: 6251 SJD AB
Category: Informational May 2011
ISSN: 2070-1721
Using Kerberos Version 5
over the Transport Layer Security (TLS) Protocol
Abstract
This document specifies how the Kerberos V5 protocol can be
transported over the Transport Layer Security (TLS) protocol in order
to provide additional security features.
Status of This Memo
This document is not an Internet Standards Track specification; it is
published for informational purposes.
This document is a product of the Internet Engineering Task Force
(IETF). It represents the consensus of the IETF community. It has
received public review and has been approved for publication by the
Internet Engineering Steering Group (IESG). Not all documents
approved by the IESG are a candidate for any level of Internet
Standard; see Section 2 of RFC 5741.
Information about the current status of this document, any errata,
and how to provide feedback on it may be obtained at
http://www.rfc-editor.org/info/rfc6251.
Copyright Notice
Copyright (c) 2011 IETF Trust and the persons identified as the
document authors. All rights reserved.
This document is subject to BCP 78 and the IETF Trust's Legal
Provisions Relating to IETF Documents
(http://trustee.ietf.org/license-info) in effect on the date of
publication of this document. Please review these documents
carefully, as they describe your rights and restrictions with respect
to this document. Code Components extracted from this document must
include Simplified BSD License text as described in Section 4.e of
the Trust Legal Provisions and are provided without warranty as
described in the Simplified BSD License.
This document may contain material from IETF Documents or IETF
Contributions published or made publicly available before November
10, 2008. The person(s) controlling the copyright in some of this
material may not have granted the IETF Trust the right to allow
modifications of such material outside the IETF Standards Process.
Without obtaining an adequate license from the person(s) controlling
the copyright in such materials, this document may not be modified
outside the IETF Standards Process, and derivative works of it may
not be created outside the IETF Standards Process, except to format
it for publication as an RFC or to translate it into languages other
than English.
Table of Contents
1. Introduction and Background .....................................2
2. Kerberos V5 STARTTLS Extension ..................................3
3. Examples ........................................................4
4. STARTTLS-Aware KDC Discovery ....................................5
5. Server Certificates .............................................6
6. IANA Considerations .............................................7
7. Acknowledgements ................................................7
8. Security Considerations .........................................7
9. References ......................................................8
9.1. Normative References .......................................8
9.2. Informative References .....................................8
1. Introduction and Background
This document describes how a Kerberos V5 [RFC4120] implementation
may upgrade communication between clients and Key Distribution
Centers (KDCs) to use the Transport Layer Security (TLS) [RFC5246]
protocol.
The TLS protocol offers integrity- and privacy-protected exchanges
that can be authenticated using X.509 certificates, OpenPGP keys
[RFC6091], and usernames and passwords via Secure Remote Password
(SRP) [RFC5054].
There are several reasons to use Kerberos V5 over TLS.
o It prevents downgrade attacks affecting, e.g., encryption types
and pre-auth data negotiation. The encryption type field in
KDC-REQ and the METHOD-DATA field with the requested pre-auth
types from the server in KDC_ERR_PREAUTH_REQUIRED errors in
KDC-REP are sent without integrity or privacy protection in
Kerberos V5. This allows an active attacker to replace the
encryption type with a compromised encryption type, e.g., 56-bit
DES, or request that clients should use a broken pre-auth type.
Since clients in general cannot know the encryption types other
servers support, or the pre-auth types servers prefer or require,
it is difficult for the client to detect if there was a man in the
middle or if the remote server simply did not support a stronger
encryption type or preferred another pre-auth type.
o Kerberos exchanges are privacy protected. Parts of many Kerberos
packets are transferred without privacy protection (i.e.,
encryption). That part contains information, such as the client
principal name, the server principal name, the encryption types
supported by the client, the lifetime of tickets, etc. Revealing
such information is, in some threat models, considered a problem.
o It provides additional authentication against the KDC. In some
situations, users are equipped with smart cards with an RSA
authentication key. In others, users have an OpenPGP client on
their desktop, with a public OpenPGP key known to the server.
o It provides explicit server authentication of the KDC to the
client. In traditional Kerberos V5, authentication of the KDC is
proved as a side effect that the KDC knows your encryption key
(i.e., your password).
The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
"SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
document are to be interpreted as described in RFC 2119 [RFC2119].
2. Kerberos V5 STARTTLS Extension
The STARTTLS extension uses the Kerberos V5 TCP extension mechanism
[RFC5021]. The extension uses bit 0 in the extension bitmask.
The protocol is as follows. The client requests the extension by
setting the STARTTLS bit in the TCP extension mechanism bitmask.
(How to deal with extension negotiation failures at this point is
described in [RFC5021].) After the server has sent the 4-octet value
0x00000000 to indicate support of this extension, the stream will be
controlled by the TLS protocol and its framing. The TLS protocol is
initiated by the client.
Typically, the client initiates the TLS handshake protocol by sending
a client hello, the server responds, and the handshake continues
until it either succeeds or fails.
If, for any reason, the handshake fails, the STARTTLS protocol will
also fail, and the TLS error is used as the error indication. In
this case, no further messages can be exchanged over the same TCP
session.
If the handshake succeeds, the Kerberos V5 authentication protocol is
performed within the protected TLS channel, like a normal TCP
Kerberos V5 exchange. In particular, this means that every Kerberos
V5 packet will be prefixed by a 4-octet length field that indicates
the length of the Kerberos V5 packet.
When no further Kerberos V5 messages need to be transferred in the
TLS session, the TLS session MUST be shut down properly using the
close_notify alert. When the TLS session is shut down, the TCP
connection cannot be re-used to send any further data and MUST be
closed.
3. Examples
A complete packet flow for a successful AS-REQ/REP exchange protected
by this mechanism will be as follows. The "STARTTLS-bit" is a
4-octet value with only the bit allocated for this extension set, and
| is the binary OR operation.
Client Server
[ Kerberos V5 TCP extension mechanism negotiation starts ]
0x80000000 | STARTTLS-bit -------->
0x00000000
<--------
[ TLS negotiation starts ]
ClientHello -------->
ServerHello
Certificate*
ServerKeyExchange*
CertificateRequest*
<-------- ServerHelloDone
Certificate*
ClientKeyExchange
CertificateVerify*
[ChangeCipherSpec]
Finished -------->
[ChangeCipherSpec]
<-------- Finished
[ Kerberos V5 negotiation starts ]
4-octet length field
Kerberos V5 AS-REQ -------->
4-octet length field
Kerberos V5 AS-REP
<--------
* Indicates optional or situation-dependent messages that are not
always sent
4. STARTTLS-Aware KDC Discovery
Section 7.2.3 of Kerberos V5 [RFC4120] describes how Domain Name
System (DNS) SRV records [RFC2782] can be used to find the address of
a KDC. We define a new Service of "kerberos-tls" to indicate that
the particular KDC is intended to support this STARTTLS extension.
The Proto (tcp), Realm, TTL, Class, SRV, Priority, Weight, Port, and
Target have the same meaning as in RFC 4120.
For example:
_kerberos-tls._tcp.EXAMPLE.COM. IN SRV 0 0 88 kdc1.example.com.
_kerberos-tls._tcp.EXAMPLE.COM. IN SRV 1 0 88 kdc2.example.com.
5. Server Certificates
The TLS protocol may be used in a mode that provides server
authentication using, for example, X.509 and OpenPGP.
A goal for the protocol described in this memo is that it should be
as easy to implement and deploy on clients as support for UDP/TCP.
Since many client environments do not have access to long-term
storage, or to long-term storage that is sufficiently secure to
enable validation of server certificates, the Kerberos V5 STARTTLS
protocol does not require clients to verify server certificates. If
server certification had been required, then environments with
constrained clients such as those mentioned would be forced to
disable TLS; this would arguably be worse than TLS without server
certificate validation, as the use of TLS, even without server
certificate validation, protects against some attacks that Kerberos
V5 over UDP/TCP does not. For example, even without server
certificate validation, TLS does protect against passive network
sniffing aimed at tracking Kerberos service usage by a given client.
However, note that the use of TLS without server certificate
verification opens up a range of active attacks such as man in the
middle.
When clients have the ability, they MUST validate the server
certificate. For this reason, if a KDC presents an X.509 server
certificate over TLS, it MUST contain an otherName Subject
Alternative Name (SAN) identified using a type-id of
id-krb5starttls-san. The intention is to bind the server certificate
to the Kerberos realm for the purpose of using Kerberos V5 STARTTLS.
The value field of the otherName should contain the realm as the
"Realm" ASN.1 type.
id-krb5starttls-san OBJECT IDENTIFIER ::=
{ iso(1) identified-organization(3) dod(6) internet(1)
private(4) enterprise(1) gnu(11591)
shishi(6) krb5starttls-san(1) }
To validate a server certificate, the client MAY use local
configuration (e.g., a list that maps the Kerberos realm to a copy of
the server's certificate) and compare that with the authentication
information provided from the server via TLS. For illustration, the
server certificate could be an X.509 certificate or an OpenPGP key.
In this mode, the client needs no processing related to id-
krb5starttls-san.
When the server presents an X.509 server certificate, clients MAY use
"Certification Path Validation" as described in [RFC5280] to validate
the KDC server certificate. In addition, unless the client can
otherwise verify that the server certificate is bound to the KDC of
the target realm, the client MUST verify that the server certificate
contains the id-krb5starttls-san SAN and that the value is identical
to the intended Kerberos realm.
6. IANA Considerations
Per [RFC5021], the IANA has allocated a bit (value 0) in the
"Kerberos TCP Extensions" registry for Krb5 over TLS, the extension
described in this document.
7. Acknowledgements
Miguel A. Garcia, Sam Hartman, Jeffrey Hutzelman, Magnus Nystroem,
and Peter Saint-Andre (in alphabetical order) provided comments that
improved the protocol and document.
8. Security Considerations
The security considerations in Kerberos V5, TLS, and the Kerberos V5
TCP extension mechanism are inherited.
Note that TLS does not protect against man-in-the-middle attacks
unless clients verify the KDC's credentials (X.509 certificate,
OpenPGP key, etc.) correctly. Although certificate validation adds
an extra layer of protection, that is not considered strictly
necessary to improve the security profile of Kerberos V5 as outlined
in this document.
If server authentication is used, some information about the server
(such as its name) is visible to passive attackers.
To protect against the inherent downgrade attack in the extension
framework, implementations SHOULD offer a policy mode that requires
this extension to always be successfully negotiated, for a particular
realm, or generally. For interoperability with implementations that
do not support this extension, the policy mode SHOULD be disabled by
default.
9. References
9.1. Normative References
[RFC2119] Bradner, S., "Key words for use in RFCs to Indicate
Requirement Levels", BCP 14, RFC 2119, March 1997.
[RFC2782] Gulbrandsen, A., Vixie, P., and L. Esibov, "A DNS RR for
specifying the location of services (DNS SRV)", RFC 2782,
February 2000.
[RFC4120] Neuman, C., Yu, T., Hartman, S., and K. Raeburn, "The
Kerberos Network Authentication Service (V5)", RFC 4120,
July 2005.
[RFC5021] Josefsson, S., "Extended Kerberos Version 5 Key
Distribution Center (KDC) Exchanges over TCP", RFC 5021,
August 2007.
[RFC5246] Dierks, T. and E. Rescorla, "The Transport Layer Security
(TLS) Protocol Version 1.2", RFC 5246, August 2008.
[RFC5280] Cooper, D., Santesson, S., Farrell, S., Boeyen, S.,
Housley, R., and W. Polk, "Internet X.509 Public Key
Infrastructure Certificate and Certificate Revocation List
(CRL) Profile", RFC 5280, May 2008.
9.2. Informative References
[RFC5054] Taylor, D., Wu, T., Mavrogiannopoulos, N., and T. Perrin,
"Using the Secure Remote Password (SRP) Protocol for TLS
Authentication", RFC 5054, November 2007.
[RFC6091] Mavrogiannopoulos, N. and D. Gillmor, "Using OpenPGP Keys
for Transport Layer Security (TLS) Authentication",
RFC 6091, February 2011.
Author's Address
Simon Josefsson
Simon Josefsson Datakonsult AB
Hagagatan 24
Stockholm 113 47
Sweden
EMail: simon@josefsson.org
URI: http://josefsson.org/